whpthomas
Q: I have it running connected to a A4988 stepper driver at 7v, 450ma and 8 micro-steps - the stepper motor gets very hot running continuously. The only way I can get it to run without overheating is to enable driver, drive for less than 1 turn (160 steps) then disable the driver and wait a second. This will be OK for my application, but just running a homing cycle over the full length causes it to get Просмотреть более
Задавает whpthomas на 2021-03-17 06:03:49
We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you’ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
Slangw hanger - It can not be overloaded. The cause of overload is mainly divided into two parts. The torque and the force of the shaft, the load torque can't exceed the rated torque of the motor. The force of the ... Просмотреть более
2021-03-29 22:39:50 полезный (0)