Wendy yep, sure will.

Wendy No. Hubsan zino 2 uses wifi-powered FPV, whereas these goggles use 5.8 ghz vtx FPV. For the husband zino 2, the FPV only connects to your phone or tablet that connects to the controller. You can't use these goggles any others for that matter with the Husband Zino 2.

Wendy Maybe this will help: for sma male, you need an rpsma female. for sma female, you need an rpsma male. Whichever one the goggles are, you need to have the opposite on the antenna (and for anything really). If one is male, you need the other to be female. if one is sma, you need the other to be rpsma. You get different combinations by combining the male-female and the sma-rpsma. Hopefully that makes sense??

Wendy Unfortunately, no. The reason is because this google (and most other goggles) operate on a frequency of 5.8ghz. This is a typical FPV radio wave. Mavic Mini and all other DJI equipment use their patented technology called OccuSync. The only way you can get FPV goggle feed from your mavic mini is by buying the DJI goggles. They average around $500 and are available pretty much anywhere, including the DJI website. Hope this helps.

Wendy Yep sure does. It will also work with any ~5.8GHz VTX+camrera

Wendy No. This goggle comes with a 1000mah 2s Lipo Battery to power it.

Wendy No, it is different. 5.8Ghz is a radio wave signal, 5G wifi is an electromagnetic signal. They are totally different and will not work together.

Wendy this is a high powered performance drone. unless the operator is very experienced, this is not a great starter drone. Goes like 80-90 mph.

Wendy To be honest, 1100mah is enormous. Personally I would go no larger than 850mah 4S unless u wanted to go 3S in which case you could do up to 1000mah MAXIMUM. I still think that is a little too large. Here is my suggestion: Tattu R-Line 4S LiPo 95C 850mAh with xt-30 connector. That would be my first pick. Hope this helps.

Wendy I had a bit of a problem when I first got it as well as I am used to a balance charger. It turns out that with this unit your battery pack has to be plugged into BOTH the Main Port (xt60 side) AND the Balance Port (2-6S connector side) in order to charge. NOT one or the other. The extra attachements should be ignored. Otherwise it will give a Cell Volt Error or a Port Error of some sort and will not operate. If this does not help then something is wrong with the unit from the manufacturer.

Wendy probably the eachine tyro 99 or tyro 109. if you don't mind spending a little more a 3 inch Diatone of some sort would be my first choice.

Wendy Absolutely - you can use 2-4S lipos on this drone. but you might find that you would want more power than a 2S. My first choice would be a 4S 850-1000mah 75-100C lipo. You definitely would not want to put more than a 4S on there though. It Burn out your ESC board.

Wendy I'm actually in a similar boat with this (though not the same) but maybe this video will help: Go to spektrumrc.com and go to the page of the 4650 receiver and there is a video on the page. Maybe that will help(?)