RayBlueSky
мое содержание
Все сообщения
Отзывы
Комментарии
ответы
Вопросы

Все сообщения

Инвертор напряжения на 500/1000/1500 Вт для автомобилей, транспортных средств и домов на колесах с постоянным током 12/24 В на переменный ток 220 В
US$34.99 US$79.99

Q: does this inverter take 24 volts

Задавает RayBlueSky на 2022-04-14 07:01:00
Оплатить
ответы (0)
RayBlueSky 27/11/2021
Lots of features and the IR controller has an excellent distance range and perfect for to light up the Xmas tree and front of the house, i used insulation tape on the plug/connectors to avoid water ingress, i put the IR receiver unit inside a clear plastic food container for extra water proofing and the IR works well over distance. Very Pleased Indeed.
5M/10M 5050SMD RGB Водонепроницаемая / Не водонепроницаемая световая лента LED Strip Light + Пульт дистанционного управления + Блок питания UK DC12V
US$10.99 US$13.99
0
рекомендации
Комментарии (0)
RayBlueSky 27/11/2021
I bought this controller to slow a 25kg servo to open and close a window so our cats could come and go as they please, the servo is controlled by IR motion sensors, please note to use it as a servo slower you need to solder a bridge between the 2 pads on the reverse of the controller. Very Pleased with this item, Many Thanks BG
Профессиональный преобразователь сигнала сервопривода с задержкой для модели RC, возможностью медленного преобразования и улучшенной реализации DIY
US$14.99 US$17.99
0
рекомендации
Комментарии (0)
RayBlueSky 27/11/2021
Working Perfectly. There are plenty of YouTube Vids to help with setting up, 4 Months on and still working perfectly, Very Happy and confident to let it do the charging of the standby batteries for when the sun sets.
PowMr MPPT 60A Солнечный контроллер заряда и разряда 12V 24V 36V 48V Авто для Max PV 190VDC свинцово-кислотного литиевого аккумулятора
US$129.99 US$195.36
0
рекомендации
Комментарии (0)
RayBlueSky 27/11/2021
An Excellent Powerful servo, I used it to open and close a window, Very smooth and precise control,
DSSERVO DS3225 25KG 180 градусов Металлический редуктор с высоким крутящим моментом и защитой от влаги для радиоуправляемого самолета, робота или автомобиля
US$17.99 US$23.99
0
рекомендации
Комментарии (0)

RayBlueSky TheUK does not have a BG UK warehouse. if you have a problem you wont be able to send it back to the UK warehouse, on the upside they do help anyway possible ;-)

fixxon 10/12/2020
Great Printer. Came in 7days via the UK Warehouse. Box was in perfect condition Took about 20 mins to complete the rest of the build (bottom half is already assembled in the box) and check all bolts, angles and connectors. Did a quick levelling and the first print (mini piggy bank) came out ok with standard thickness layers(0.12mm). Although the free filament was nowhere near enough to try a test print. since brought it has done around 200 hours worth of printing with most of that time taken to print parts for a lack enclosure :) added some pics of the build out of the box, the piggy, first few layers of a cable chain and a 7 inch pikachu(before being sanded and detailed)
Принтер Creality 3D® Ender-3 с размером печати 220x220x250 мм и функцией продолжения печати при отключении питания
US$269.00 US$499.00
6
Комментарии (4)
RayBlueSky 09/06/2020
This review is for the 5A version, now for the pros and cons of this tiny ESC, The Pros are as follows... its Small and perfect to use on the hand launch gliders sold on Banggood, i used it to power the Eagle Hand Launch Glider, This Allowed me lots of space for the FrSky receiver. I used it to power 2 coreless brushed motors both clockwise and counter clockwise making sure to observe the polarity of each motor to ensure they spun/turned in opposition direction. The Cons are as follows... The 5A items i received were slightly different to the pictures so be careful when soldering the RC in connections and possibly use glue to hold the wires in place once soldering is done. I tried every way possible to calibrate the ESC as per the instructions to hear the beeps at Full Throttle and Zero Throttle, regardless of settings it worked and did not need calibration, the only problem i had was when i throttled up the motors they would make a loud BeeeeeeeP whilst the motors are running, it may be that having 2 motors connected causes the problem so i will try one motor as a test on another design. My next one will be the Hand Launch Pterodactyl on Banggood so the Beeeeeping noise will sound perfect as it is flying. I hope this information is helpful for Micro Fliers. Best Regards RBS
Ультралегкий мини-матовый ESC односторонний 5A/10A 1S LIPO Электрический регулятор скорости в одну сторону ESC DIY для микроуправляемых самолетов С
US$9.99 US$11.99
0
рекомендации
Комментарии (1)
RayBlueSky 13/05/2018
If you are planning a small build airplane then this will do the job if you don't need a rudder... The FC has an excellent BEC to power Rx, servos, FPV camera, VTX and a small GPS, I opted to flash it with INAV and it works perfectly. The GPS is best connected to Uart 2 and I highly recommend the Mini Dual GLONASS BN-180 with this FC for airplane only as INAV doesn't need a compass or baro for direction or altitude... RTH works brilliantly with 18 sats fix using the gps mentioned, I plan to use in larger builds as I have had excellent results so far. Regards RBS
Omnibus F3 NANO STM32F303 Контроллер полета 2-4S 20 * 20 мм 3,7 г Встроенный 5V 3A BEC OSD LC Filter для RC Дрон
US$17.99
0
рекомендации
Комментарии (0)
RayBlueSky 13/05/2018
Absolutely perfect... getting 18+ satellite's fix with this tiny GPS Module, I couldn't ask for more, INAV picked it up no problem once the Uart port settings were setup. I recommend whole heartedly. Regards RBS
Битиан Самый Маленький Мини двойной GLONASS + GPS BN-180 Микро Двойной GPS Антенна Модуль UART TTL для CC3D F3 RC Drone Авиамодель
US$18.99 US$51.59
0
рекомендации
Комментарии (0)
RayBlueSky 04/03/2018
Perfect choice for a flying wing, Comes with Beta Flight... For some reason I couldn't get the GPS to work on Beta Flight so I flashed Inav on it and GPS worked perfectly on Uart 2. I can confirm you can either power the FC from the B+/B- on the board or via the multi plug Vcc/Grd. The default camera voltage/ram pin was 5V without soldering the bridge, I didn't actually use the ram voltage as I wasn't confident enough to solder the bridge as per the directions. The pin holes are a fraction too small to accept standard pins unless you file them round to insert in the pcb, I removed the standard black pin shells and used heat shrink for insulation. All looks good at the moment. Time will tell
Omnibus F3 NANO STM32F303 Контроллер полета 2-4S 20 * 20 мм 3,7 г Встроенный 5V 3A BEC OSD LC Filter для RC Дрон
US$17.99
3
рекомендации
Комментарии (0)
RayBlueSky 04/03/2018
Long enough for most locations
10 см 2dBi 5.8Ghz IPX FPV Антенна Сгибаемый гибкий для RC Дрон
US$2.07 US$3.48
0
рекомендации
Комментарии (0)
RayBlueSky 04/03/2018
Well machined adaptor and looks good in black
3мм / 3,17мм Алюминиевый адаптер винта пропеллера для безщеточного мотора
US$2.80 US$13.19
0
рекомендации
Комментарии (0)
RayBlueSky 04/03/2018
The staple servo for those smaller craft, nice action but untested as yet.
4X SG51R 5г Пластиковое шестереночное цифровое микросерво для RC самолета
US$17.99 US$21.59
0
рекомендации
Комментарии (0)
RayBlueSky 04/03/2018
This one has fired my imagination insomuch as it so well designed as an easy to build wing, I am really looking forward to flying this one :-)
Дух 600-мм размах крыльев EPP FPV Racer Flying Wing RC самолет KIT
US$37.99 US$55.99
0
рекомендации
Комментарии (0)
RayBlueSky 04/03/2018
I am very impressed with this GPS, OK its not the full all singing and dancing M8N but considering its size an weight its perfect for a wing or aircraft, worked perfectly out of the packet with Inav and 6 sats indoors,
Битиан Самый Маленький Мини двойной GLONASS + GPS BN-180 Микро Двойной GPS Антенна Модуль UART TTL для CC3D F3 RC Drone Авиамодель
US$18.99 US$51.59
0
рекомендации
Комментарии (0)

Вы эксперт, можете ли вы помочь?

Мы искренне приглашаем вас подписаться на рассылку с ответом на приглашение!

Если вы подпишетесь, мы будем приглашать вас по электронной почте, чтобы ответить на вопросы людей о продуктах. Оформив подписку, вы также получите "Полезный значок "! Вы можете отказаться от подписки в любой момент на странице настроек конфиденциальности.

Помогайте другим и будьте счастливее!

  • Подписаться

О бейджах

Значки связаны с сообществом, и пользователи зарабатывают значки, создавая качественный контент, выполняя миссии или участвуя в специальных мероприятиях. У определенных людей также будет свой собственный эксклюзивный значок.
Значок генерального директора

Значок генерального директора принадлежит только начальнику Banggood.

Значки, которые вы можете заработать, скоро появятся
  • OK

About Badges

Badges are related to the community, and users earn badges by creating quality content, completing missions, or by participating in special activities.

Helpful Badges

The Badge is awarded to users who are subscribed to the Invite Answer email and signifies their gratitude to help others. The badge appearance upgrades as the user helps more people.
  • OK

Thank you for subscribing! You have also earned a badge!

  • View It

Thank you! Your answer will help ###name### and ###num### other people!

Check awaiting answers to see more people who need help.

  • OK

Thank you! Your answer will help ###name### and ###num### other people!

Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!

  • Subscribe

Are you ready to help?

We invite you to subscribe to our Invite Answer email!

Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.

  • Subscribe