genivos
Tjb4764 Camera model: Foxeer Falkor (Full size), Flight controller model: Airbot Omnibus F4 Fireworks v2 (OMNIBUSF4SW), Firmware version: Betaflight 3.5.1, Pad label: Camera Control, resource CAMERA_CONTROL 1 B09, camera_control_mode = default (HARDWARE_PWM), camera_control_ref_voltage = default, camera_control_key_delay = default, camera_control_internal_resistance = default, Additional comments: OSD pin camera -> camera control pad FC / GND pin -> GND FC, no additional caps or resistors needed
2018-09-27 03:58:28 полезный (0)
genivos There's one wire on the FC (blue) awful close connected to the top most ESC wire. That ESC power wire has a pretty big goop. Not sure if that caused a short, difficult to see on the pic .. it's just awful close.
Мы искренне приглашаем вас подписаться на рассылку с ответом на приглашение!
Если вы подпишетесь, мы будем приглашать вас по электронной почте, чтобы ответить на вопросы людей о продуктах. Оформив подписку, вы также получите "Полезный значок "! Вы можете отказаться от подписки в любой момент на странице настроек конфиденциальности.
Помогайте другим и будьте счастливее!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
