anubhav.m
Q: Hi just wanna ask question is this item would work in windows 10 operating system?
Задавает jeric busca на 2018-12-07 09:40:47
anubhav.m Yes
2019-02-27 08:43:50 полезный (0)Q: If it is sensorless, what are the thin wires for?
Задавает henrivdr на 2018-07-04 04:00:44
anubhav.m They are hall sensors for rotor position encoding. R - VCC Blk - GND Other three are HA HB HC concurrent to the phases A B C. It's a sensored bldc motor.
2018-08-22 03:11:44 полезный (0)
anubhav.m The motor is a sensored brushless motor designed for burst powers. I doubt it is designed for 2500W continuous power. Since, there are no countermeasures for heat, and no fans either. I work on BLDC motors, the generic ones used in smaller bikes and cars. Trust me, minutes of running gets them hot. As for the wires, same as the point I was trying to make earlier, I don't think it's designed to be used continuously, but for smaller time of burst power it'll work just fine! But if you run it non stop for more than a few minutes, it'll melt alright.
2018-08-22 03:08:54 полезный (0)Мы искренне приглашаем вас подписаться на рассылку с ответом на приглашение!
Если вы подпишетесь, мы будем приглашать вас по электронной почте, чтобы ответить на вопросы людей о продуктах. Оформив подписку, вы также получите "Полезный значок "! Вы можете отказаться от подписки в любой момент на странице настроек конфиденциальности.
Помогайте другим и будьте счастливее!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
anubhav.m Runit off a external supply. Prolly the current is not enough as 200mA is a lot of current to take over GPIO header...