BG543203818 The receiver must have the declared FailSafe function. The connection of RX to Kopilot is via PWM connection! Then we proceed as follows: 1. Insert the "bind" coupling into the Bind position RX. 2. Connect the RX power supply. The LED in the RX flashes faster. 3. Pull out the "binding" coupling. The LED in the RX flashes slower. 4. On TX, set the signals in CH and the controls to the values required when the connection is lost. 5. Press the "bind" button on the TX permanently, then switch on the TX. 6. Wait for the LED in the RX to light up permanently. This completes the FailSafe programming process. The control surfaces move to the positions required when the connection is lost. 7. We verify the function by changing the positions of the control surfaces. Then we turn off TX, break the connection. The control surfaces must immediately assume the positions required in the event of a loss of connection - FailSafe.