Все сообщения

Q: Which polarization direction the cleaver antenna has on this helmet?

Задавает shark3v на 2020-03-09 09:46:34

ThompTech RHP. Right Hand polarization is the default for most systems. Left hand is used when you are near a person using RHP (such as a race event) to help with interference as RHP and LHP interfere with each other less than when both pilots use RHP..

2020-03-12 10:54:55 полезный (2)
Оплатить
ответы (3)

Q: This 4in*****a esc work with F3 Flight controller Acro 6DOF.?

Задавает binh ha на 2020-02-28 10:21:58

ThompTech Yes it will. This esc will work with essentially every f3 or later board.

2020-03-12 10:50:51 полезный (0)
Оплатить
ответы (2)

ThompTech The red light comes on when the unit is charging. The green light comes on when the unit is finished charging. This may indicate an issue with the battery or charging system.If the wall charger isn't working try the USB charger. If neither works that would point to your goggles having the issue. If one charger works and the other does not then its likely the charger.

2020-02-05 07:01:35 полезный (1)
Оплатить
ответы (2)

ThompTech 1. Pull is same as thrust/lift in this case and refers to the grams of thrust produced at a given volt/amp. 2. This motor can run on a 3S 11.1v lipo or a 4S 14.8v lipo battery. The the 14.8v draws more amperage @ 27A and provides more pull/thrust. Hope that clears it up.

2020-01-08 04:57:41 полезный (0)
Оплатить
ответы (2)

Q: what can be the minimum measured voltage for 1 cell 3V / 2.5V?

Задавает AndrzejG22 на 2019-05-14 11:45:17

ThompTech Don't go below 3.2 volts or the charger will likely give a low voltage error and refuse to charge the cell. Also do not charge each cell beyond 4.2 volts or you risk fire and or damage to battery life.

2020-01-07 09:20:37 полезный (1)
Оплатить
ответы (1)

thompson49022 If coil is not working then replacement would be based on if you are still in warranty. Check your motor manufacturer's warranty and if you are within its coverage time submit a claim and they will take care of it. I would start with warranty check and if its still in warranty get the free replacement. Otherwise, try epoxy applied with a tooth pick. Try to keep the loose coil in its original shape as much as possible then use the epoxy to hold it to the parent coil. Cheers!!

2020-01-07 09:03:04 полезный (0)
Оплатить
ответы (2)

Q: Can it read ibus?

Задавает bluehell на 2019-09-09 03:32:14

thompson49022 This particular model does NOT use iBus. It does work with SBUS, PPM, DSM and PWM signals.

2020-01-07 09:00:00 полезный (0)
Оплатить
ответы (1)