nabla yes, you propably have a configuration error. Check the ports tab define Uart6 as serial RX and in config tab select serial-rx and then sbus. use the pad that says SBUS. I have had the same problem. was it uart6? i am not shure, but only one of them works as sbus!!

nabla had the same problem, u must flash it with OMNIBUSF4SD, note SD!!, Ports: activate SerialRx, Config: select serial based receiver and SBUS

nabla yes, but here is my advice: dont ;) These are not very melt-proof. These are rather cheap. user 2206er 1800kv-is motors. Your motors seem very very powerful. Better use 45A+

nabla had the same problem, u must flash it with OMNIBUSF4SD, note SD!!, Ports: activate SerialRx, Config: select serial based receiver and SBUS

nabla LBT is D16, you need to flash D8 on your sender if it does not have it (in the menux next to where you bind stuff). Search a yt video where someone flashes D8 on the same type of transmitter. If it exists -> proof(it does work), it if does not exist -> kind of proof that it does not work. Anyways I flashed beta flight 4.1 on it (which i recommend besides JESC 48khz!!!) and you can just select betwen D, X and LBT which is D8, D16-FCC and D16-LBT

nabla u must flash it with OMNIBUSF4SD, note SD!!, Ports: activate SerialRx, Config: select serial based receiver and SBUS

nabla confirmed, for everybody who is ancious about it, it is the NOX although it says target:NOX1