Ianlaing1
- мое содержание
- Все сообщения
- Отзывы
- Комментарии
- ответы
- Вопросы
ответы
Q: well this work with happy model elrs receivers too, or just yours?
Задавает Scotty2Quady на 2021-07-17 09:16:40
Q: Will this work with x8r receiver?
Задавает Colin Doughty на 2021-06-19 16:02:35
Ianlaing1 no
полезный (0)Q: is it suitable with Jumper t-lite transmitter?
Задавает KarloBalboa на 2021-04-19 14:37:48
Ianlaing1 if you have a 3d printer then no
полезный (0)
Ian The Post for the tx805 json from github will work at rated power the TX805S.. ignor the fact it say 800, its actually providing the full at 1.6w at the 4th power setting...
полезный (0)
Q: do you have a direct drive version (not Bowden Long range but direct drive for bondtech prusa setup)
Задавает Paul Cole на 2019-03-27 20:40:45
Ian depending on setup with work with say a titan extruder which uses a short PTFE tube ..
полезный (0)
Q: where can I plug SUMD (graupner sbus) ?
Задавает aircraftfire07 на 2019-03-06 15:49:56
BG451864550 rx3
полезный (0)
Q: will this work on normal r9m? like r9mm normal does?
Задавает FTJ на 2019-09-28 11:03:36
ian.laing I was not able to use this receiver with the non access R9M module :( rather buy non access receivers for older modules.. Maybe someone else has managed to use this receiver in with r9m TX..?
полезный (0)
Q: Can't seem to find a termination plug that fits. Could you link one?
Задавает rippst на 2018-11-30 04:56:44
ian.laing there appears to be no dummy 50 ohm available for these. Makes them useless. Rather buy the other antenna that have male not female like these...
полезный (0)
Ianlaing1 will work with any expresslrs flashed hardware.
полезный (1)