T12 Цифровая Пайка Станция OLED Дисплей Плата управления STC Контроллер Набор
Часть обзора переведена автоматически.
I have both this controller and one with 7 segment display ( https://goo.gl/P4pkWP ) This one have nicer software and is a bit easier to setup and use, but it is a little lower build quality. Overall, they're both quite good, and I cannot decide which one to keep :)
sono soddisfattissimo del mio controllore digitale di temperatura Hakko T12 ,velocissimo nel raggiungere la temperatura da me voluta ,molto preciso nel mantenerla,il display oled mi da tutte le informazioni relative a temperature e tensioni di esercizio e se saldate la NTC nella ( fornita nel kit insieme al sensore di movimento ) nella apposita piazzola potete anche rilevare la temperatura interna al case. Ho accoppiato il regolatore ad un porta stilo D-T12 ( già completo di sensore movimento e spinotto a5 poli)è una punta saldante T12 -ILS A PUNTA FINISSIMA . Il sistema funziona benissimo anche per lunghi periodi,la maniglia del porta stilo è perfettamente isolata dal calore generato . ATTENZIONE ,PRIMA DELL COLLEGAMENTO DEL SALDATORE VERIFICARE IL CORRETTO COLLEGAMENTO DEL CABLAGGIO . Vedere foto allegate .
Хороший набор для модернизации T12 DSK. Комплекту не хватает зенковки оргстекла под штатные 4 винта. Оргстекло лучше было бы прозрачным - с тонированным видимость знаков не очень хорошая.
Is binnen nog niet getest
Funziona perfettamente, se non collegate il termistore il sensore di movimento non funziona (probabilmente è colpa del manico che ho collegato) e prende, come temperatura di riferimento per la cold junction, 20C. La placchetta acrilica fornita è troppo scura, se c'è troppa luce è difficile leggere il display. Per il resto è perfetto, raggiunge la temperatura di esercizio in pochi secondi e la mantiene senza problemi.La funzione di standby accresce la vita della punta.
I did an upgrade from a clasic soldering iron with no temprature control,and this station is perfect ,i did had to make an enclosure for it, but it was a breeze i did it from a gopro package and some wood, i think its good looking,for supply i used a charger from a laptop 18V 2.6A.I had to calibrate the temprature with a multimeter.If i find a 24V 3A charger its much better, so this is a good station diy. thank you
good product
Prodotto arrivato nei tempi previsti e perfettamente imballato. A presto per le foto della mia stazione di saldatura!!
Good quality, fast shipping.
I received this kit in good state well packaged. I highly recommend buying this product.