Отзывы покупателей

4.96 из 5
Написать отзыв
  • Все отзывы (53)
  • Образ (5)
  • Видео (0)
  • Все звезды
    • Все звезды(53)
    • 5 Звезда(51)
    • 4 Звезда(2)
    • 3 Звезда(0)
    • 2 Звезда(0)
    • 1 Звезда(0)
Сортировать по:
  • оценке
  • полезности
  • дате
Отзывы только из вашей страны (Armenia)
  • August-31 2020 06:58:48

    товар пришел быстро (2 недели до спб). Продавцом остался доволен. Пружины очень жесткие это плюс. от колес толку не много. больше брал как дэкор

  • October-23 2020 01:56:45

    la calidad se nota mucho y tiene un acabado increíble

  • January-03 2021 10:39:24


  • August-05 2020 19:22:29


  • July-22 2020 09:37:07

    Excellent and a must have upgrade.

  • BenVIP3
    September-01 2020 00:20:22

    So, the springs are excellent as they hold the bed very steady on my Ender 3 V2. Unfortunately, the handles were not as useful as when installed, they tend to slip. I screwed on the screws on these handles and when I turn the handle, it sometimes just spins, rather than raise the bed. The original handle never slips, they raise the bed. I was a bit disappointed as they look better than the original handles but I decided to use these springs with the original handles.

    Комментарии (1)
  • September-04 2020 10:46:48

    Les ressorts de ce pack sont très bons et fonctionnent parfaitement sur l'imprimante ENDER 3 Pro. Pour l'instant, j'utilise les écrous noirs de nivellement originaux. Les 4 écrous ont l'air de très bonne qualité...mais je ne peux pas en dire plus. J'ai acheté ce jeu pour les ressorts, je suis donc globalement satisfait.

  • August-12 2020 04:27:54

    The springs in this pack are excellent. The Levelling nuts are largely fine, however the thread of one levelling nut was too large and couldn't tighten down, it just slipped instead. I am using 3 of the red nuts, and one of the original black nuts at the back. Largely I bought this set for the springs, so I am generally satisfied.

  • January-09 2021 08:14:57

    A must have upgrade for your ender 3 v2 3D printer. Massivly increased the stability of the print surface and drasically reduced the amout of bed alignments required.

  • November-07 2020 00:02:51

    A great springs and wheels for the Ender 3 pro. It was very easy to change them and they really upgraded the experience from leveling my bed before every print to once a week+ (sometimes even 3 weeks).


    Total 0 pages

    Go to page



    recommendation for you
    • US$16.99
    • US$4.23
    • US$10.72
    • US$6.99
    • US$41.99
    • US$14.76
    • US$29.99
    • US$4.79
    • US$4.99
    • US$8.99
    • US$259.00
    • US$206.00
    • US$299.00
    • US$2.39
    • US$23.99
    • US$399.00
    • US$12.49
    • US$11.99