Все сообщения

tonynux I think I buy the Kit version. Can I use a 2807 1300 KV motor? On 3s Li-Ion pack (18650) ?

2024-09-09 07:23:44 полезный (0)
Оплатить
ответы (12)

Q: How to make Telemetry working via smartport, using FrSky XSR?

Задавает tonynux на 2019-11-26 07:58:55

serg93112 не могу сказать

2021-11-03 02:36:18 полезный (0)
Оплатить
ответы (2)

armin Bestway to use this TX would be use a ESR Cap on V-Bat and power the transmitter also from your Lipo. My experience is any BCE which has to power Cam and VTX should at least have 1,5 A. Better safe than replace your Flight Controller!

2020-02-19 04:18:00 полезный (2)
Оплатить
ответы (2)

Q: are there motor soldering pads (if I want to use single ESCs)?

Задавает tonynux на 2020-04-26 09:14:29

PBlowup If you want to use individual ESC's you will need a PDB for power to you ESC's, I believe the pads marked S1 to S4 would be where you connect the signal wires from the ESC's. If you need ESC telemetry you connect to the RX6 pad. If you want an easier build a 4 in 1 compatible ESC would be a better option. I purchased this board and found that the motors for S1 to S4 are not pinned out to solder pads you can only access these via the ESC plug, however motor S5 to S8 do have connections on solder pads you would need to re-map the motors via the CLI in betaflight to change the motors to S1 to S4.

2020-07-06 09:13:38 полезный (1)
Оплатить
ответы (7)

Q: does it include a Blackbox?

Задавает tonynux на 2021-04-03 04:31:42

Patulous NO

2021-05-07 08:19:46 полезный (0)
Оплатить
ответы (1)

Q: is fly time longer on 2s or 3s (considering 2s at bigger mAh capacity)?

Задавает tonynux на 2021-01-18 01:03:19

Thurloug Guffaw Actually the flight time is about the same , 3S 450mAh around 6'30-7 mins

2021-02-03 02:02:09 полезный (1)
Оплатить
ответы (1)