Все сообщения

Q: what filaments should I use

Задавает BG851454317 на 2022-03-29 03:27:20

paulomartins Isto é uma estação de cura e lavagem para modelos feitos em impressoras de resina, não é uma impressora 3D.

2022-03-29 04:21:14 полезный (0)
Оплатить
ответы (1)

Q: What is the polarity of these magnets?

Задавает BG938353949 на 2020-11-19 06:12:56

paulomartins My friend, ANY magnet in the word has two polarities. If you break one in half, you will get two smaller magnets, both with north and south polarities.

2020-11-19 08:46:32 полезный (0)
Оплатить
ответы (2)

paulomartins Well, you must search and learn. this is a board of relays controlled by the ESP8266 board (that small detachable board on the bottom left corner). You MUST know how to program and control that board. After that you can control the relays, Search the internet for "ESP8266 for beginners", it will be very hard to find easy instructions, like in a kit.

2020-08-13 05:24:01 полезный (0)
Оплатить
ответы (2)

paulomartins This is an ESP8266 board. You must learn how to work with it. There's tons of info out there, but you must be a tech nerd, though. After that is easy.

2020-07-05 04:26:04 полезный (0)
Оплатить
ответы (1)

Q: How to connect this relay to internet

Задавает BG874810352 на 2020-05-29 04:27:02

paulomartins it has an ESP8266, so... You must learn how to connect the ESP to the internet and interact with its output pins, then move on to this.

2020-05-29 05:04:22 полезный (0)
Оплатить
ответы (2)

Q: output regulation voltage is AC or DC ???

Задавает Tomáš Zadražil на 2020-04-19 01:27:43

paulomartins AC only, no DC involved here.

2020-04-20 03:47:00 полезный (1)
Оплатить
ответы (5)

paulomartins it doesnt work. needs to be connected to charger even with full charged batteries. if we disconnect from wall charger it stops charging the phone

2020-03-10 04:26:35 полезный (0)
Оплатить
ответы (9)