Все сообщения

BG126111619 The answer by undyah is incorrect. You can do this. Just to be sure I have put it on the bench set it to PD 20V and put a 1 amp electronic load on the downstream port. The unit is reading just over 20W while the load is reading just under (expected due to voltage drop in the cable). The unit acts as a PD device and conducts the necessary negotiation. RIDEN call this process 'triggering' and there is a special page in the UI for it. You first select the PD standard and then it lists the different voltages and currents offered by the PSU you are plugged into. Select one of these and it prompts you to unplug and re-plug the device. On powering up again it commands the PSU to deliver this voltage. This is an excellent device and superb value, but the UI can be a little tricky to figure out.

2020-11-12 08:37:30 полезный (4)
Оплатить
ответы (3)

aletterjames cable has been working great. it fell in my drink in my car and still works! not rusty as I was expecting.

aletterjames 24/03/2020
1
Комментарии (1)