peter1122
- мое содержание
- Все сообщения
- Отзывы
- Комментарии
- ответы
- Вопросы
ответы
peter1122 No its not spectrum analyser. Its only rf signal generator 23-6000Mhz
полезный (2)
peter1122 Hi, Included controller, grbl controller /open source/ Open source softwares for pcb bcnc, candle. Tips: My controller board arrived 0.9 old fw and no bootloader fw upgrade not possible. Solution: save grbl setting /$$ command settings list/ flash arduino bootloader via icsp. And flash new grbl 1.1fw with xloader, and config new fw and enjoy :)
полезный (1)Q: what is the power (in Watts) of the spindle?
Задавает greatvlad на 2017-11-13 08:27:43
peter1122 This is a great little cnc machine. The spindle about same as 775 12-36 3500-9000rpm motors in BG, if load current on 24V can reach 4-5amps. This 24V ~6.000rpm not too much rpm. I replace stock 24v 6.000rpm motor to 12V 13.000rpm 775 motor and change 24V 5A power supply to 12V 10A. Less heat stepper driver higher spindle rpm! :)
полезный (2)
peter1122 A thermocouple produces a temperature-dependent voltage as a result of Seebeck effect, and this voltage can be interpreted to measure temperature. Type K (chromel–alumel) approximately 41 µV \°C.
полезный (1)