ответы

coejoe345 I haven't seen one specifically designed for this radio yet and I kinda like the foam box. Perhaps you could DIY one using the included box as a foam guide and an army surplus ammo can.

полезный (0)
Оплатить
ответы (4)

Q: What's its fimi premium care? I don't know

Задавает Mansotez на 2020-11-10 10:14:43

coejoe345 It's basically replacement insurance for specific situations offered in certain areas.

полезный (0)
Оплатить
ответы (4)

Q: What is FIMI premium care?

Задавает pwschultz на 2020-09-05 20:26:51

coejoe345 It's an additional insurance or warranty service offered in some regions. It covers damage caused by liquids, impacts, damage caused by the pilot, etc. which entitles you to up to 2 replacements in a year by paying a lesser fee per replacement.

полезный (1)
Оплатить
ответы (2)

coejoe345 With my 4-port charger the lights are flashing when idle, solid when charging, and turn off when charging complete.

полезный (0)
Оплатить
ответы (3)

coejoe345 Power on the controller by holding down the power button for 2 seconds, I think it will beep when it turns on also. Plug in the battery pack to the goggles, out of the box my drone was set to sync on Frequency R Channel 4 Band 5769. You can see how the goggles are setup by looking in the upper left of the screen, try adjusting them to that setup. The goggles also have an auto-scan function you can try: with the drone turned on push the "A" button on the goggles. To arm the drone for flight make sure the throttle is pulled completely down before turning the left AUX switch to the fully up position. Don't forget to change your Rates to the proper battery setting with drone unarmed and before adding throttle and taking flight.

полезный (0)
Оплатить
ответы (2)

Q: how do i get in the betaflight osd thru the goggles

Задавает Tobi на 2020-05-27 02:24:37

coejoe345 Throttle mid + yaw left (Left joystick) and pitch up (Right joystick). Use the right stick up and down to move the option selection arrow. Use right and left on the right stick to select and-or adjust values.

полезный (0)
Оплатить
ответы (3)