Отзывы покупателей

4.79 из 5
Написать отзыв
  • Все отзывы (28)
  • Образ (1)
  • Видео (0)
  • Все звезды
    • Все звезды(28)
    • 5 Звезда(24)
    • 4 Звезда(3)
    • 3 Звезда(0)
    • 2 Звезда(1)
    • 1 Звезда(0)
Сортировать по:
  • оценке
  • полезности
  • дате
  • jasc
    2019-07-29 04:25:20

    makes a nice light effeckt on my ar mini wing (pnp motor) wiring to FC is straight forward and its fully supported by inav ;-)

  • 2020-08-26 09:15:31


  • 2020-08-11 14:19:51

    For my PnP machine, just what I need

  • 2020-03-17 05:29:01


  • 2020-01-29 03:55:58

    Material arrived in good condition

  • _RBD_
    2018-08-16 17:48:41

    16 LED ring with addressable RGBW LEDs The LEDs is easily driven by a microcontroller for example an Arduino. Only a single data line is required for control. I had a issue where half of the PCB is geting warm. the resistor used in serie with data input was on the wrong place. the resistor is connected over 5V and ground causing a current of 15mA even if the leds are off. The resistor can be remove or swapped with the capacitor. See image. The LEDs shines good and can be set to be very bright. if

    Комментарии (1)
  • Amateur
    2017-11-16 03:35:03

    Really good product. Was a little bit confused because only 3/4th of the pixel were addressed and colors were others than programmed. Switching to RGBW instead of RGB solved the problem. Conclusion: Got a better product than advertised.

    Комментарии (1)
  • Dacques
    2018-08-17 08:47:59

    This does what I expect it to do but it is a lot smaller than I was expecting. I was hoping to use it for an IronMan costume but it is not big enough.

  • 2018-05-22 10:41:41

    Be Warned: This is not WS2812 or SK6812. After several hours of trying to find out why the last four pixels were dead and showing the wrong colors, I found that this LED also has white. The order of the pixels is GRBW. Banggood need to change the description of this item.

    Комментарии (1)
  • 2018-03-09 10:14:12

    The rings are pretty good, in programming with Arduino you must input a 21 LED number instead of 16. A couple of LED's need 2 PWM signals to go to another.


    Go to page



    recommendation for you
    • US$1.99
    • US$1.99
    • US$3.88
    • US$6.99
    • US$1.99
    • US$1.99
    • US$5.37
    • US$2.99
    • US$2.99
    • US$7.34
    • US$9.99
    • US$7.99
    • US$2.99
    • US$4.99
    • US$4.19
    • US$22.42
    • US$4.39
    • US$4.99