RF-Power8000 1Mhz-8000Mhz OLED RF Power Meter -55dBm ~ -5dBm Регулируемое значение затухания
Часть обзора переведена автоматически.
Don't forget to purchase a 2W 30dB (1000 divider) attenuator to get a direct dBm display. Mine came with a +0.3dB offset so I assume it was calibrated at the factory. I tested it with various VTX 5.8GHz transmitters and the power is very accurate, I also tried to insert a set of attenuators and got a very precise value, within +/- 0.1dB range. Very convenient to check the output power or measure the attenuation on cables and SMA connectors, I don't regret my purchase.
Surprising accuracy. A fraction of the cost of another brand but readings are the same. Very happy with this power meter.
A good and easy way to measure with this power meter. And most importantly, you get a good device for reasonable money. I did not regret what I bought. Even put the USB cable. I'm satisfied.
Fitted a 30db attenuator to measure FPV VTX modules and it seems to do the job fine.
Измеряет что-то, это может быть даже вполне нормально (значения имеют смысл при проверке мощности передачи). Но проблема в том, что заданная частота не полоса пропускания, похоже, что это верхний предел frquency LP-фильтра, так как чем больше я задаю, тем больше значение измеряется. Так что он определенно не измеряет то, что должен. Также наставлений не существует, так что я понятия не имею, смогу ли я решить проблему самостоятельно. С другой стороны, его можно использовать для сравнения антенн и проверки настроек передачи относительно выходной мощности.
Аналог ImmersionRC. Измеряет уровень РЧ сигнала. Настройками задается верхняя граница частоты измеряемого сигнала и ослабление.
ok
Works ok
nice unit!
A good and easy way to measure with this power meter. And most importantly, you get a good device for reasonable money. I did not regret what I bought. Even put the USB cable. I'm satisfied.