Открытый интеллектуальный USB в модуль адаптера Wi-Fi ESP-01S LINK V2.0 с драйвером 2104 ESP8266
Часть обзора переведена автоматически.
Прибыл целым и невредимым. Первые впечатления были теплыми, как доска выглядела неряшливо, но это был просто немытый поток. Существует удобная стрелка Ti помочь вам в получении ESP01s подключены в правильном пути вокруг, и будьте осторожны, это очень легко получить неправильно. Чтобы использовать его в качестве программы для Arduino IDE, достаточно добавить простой переключатель между IO0 и GND, чтобы перевести его во флэш-режим. Просто.
I plan to use this adapter for ESP 8266 - 01. It looks OK, but there are missing any instructions. I have found driver on internet, so the driver in my PC is OK. Adapter itself could be OK, there is 5V to 3.3V conversion, but I was not able to upload software to ESP 01 board. Missing switch GPIO0 to GND (for software upload). My ESP01 module was not S type, so maybe this was a problem.
....
While plug using 3 different item ESP8266 the unit overheat need to remove quick
For this Programmer the ESP-Module has to be placed outwards. For me the standard DTR/CTS control for programming is not working using Arduino IDE! First of all I had to solder a pullup resistor between VCC and the CD_PD pin. To put the ESP-01 in programming mode GPIO has to be pulled to ground (soldered a jumper to the pin) followed by pressing the Reset button. For Nral opreation the Jumper should be removed again.
Ottimo prodotto funziona correttamente
Прибыл в хороших условиях
Работает
Полезно для esp01s
ХОРОШИЕ ВОПРОСЫ