Отзывы покупателей

Написать отзыв
  • Все отзывы (32)
  • Образ (2)
  • Видео (0)
  • Все звезды
    • Все звезды(32)
    • 5 Звезда(29)
    • 4 Звезда(2)
    • 3 Звезда(1)
    • 2 Звезда(0)
    • 1 Звезда(0)
Сортировать по:
оценке
  • оценке
  • полезности
  • дате
Отзывы только из вашей страны (Russian Federation)
|
Показать оригинал

Часть обзора переведена автоматически.

  • 09/12/2017

    This is the only dual rail linear regulator on banggood. Works great and is really essential when working with audio and op-amps. Had to buy a second one. I wish there were more dual rail options. Led resistor is way too small value, otherwise flawless.

    Комментарии
    Показать оригинал
  • 10/02/2017

    Easy to build and very useful kit.

    Комментарии
    Показать оригинал
  • 02/08/2016

    I will use this kit as a basis for a ~1,2 to +25v, -1,2 to -25v 1A PSU. I will also use two of the 0-33V 0-3A Four Bit Voltage Current Meter, also from Banggood. The quality of the components and the PCB is good. I would like to see all the electrolytic capacitors to be at least 35v (the 330 uf ones are 25v - I will use 35v ones from my stock) but this is my personal view of how a good kit could be a better one with minimal extra cost. The kit came to Greece in 15 days, well wrapped and with everything intact. Well done one more time Banggood!

    Комментарии (3)
    Показать оригинал
  • 02/04/2019

    positive and negative voltage regulato with LM317 and LM337. the PCB is very well made, the parts are already included in the kit. my only concern is that I am not sure if the LM items are genuine or not; the LM337 has a metal tab that is very thin, but it could be ok. the supplied heatsink can only handle a limited current, so I will replace them with bigger parts. satisfied Regolatore di tensione positivo e negativo con LM317 e LM337. il PCB è molto ben fatto, le parti sono già incluse nel kit. la mia unica preoccupazione è che non sono sicuro che gli elementi LM siano autentici o meno; l'LM337 ha una linguetta di metallo molto sottile, ma potrebbe essere ok. il dissipatore in dotazione può gestire solo una corrente limitata, quindi li sostituirò con parti più grandi. soddisfatto

    Комментарии (2)
    Показать оригинал
  • 31/12/2018

    Wer eine symmetrische Spannungsversorgung (z.B. +/- 15V, 0,3A für OPV Schaltungen) benötigt, ist mit dieser Schaltung sehr gut bedient. Wie schon der Beitrag von ohyva erwähnt sollte der Widerstand R1 und R4 gegen einen Wert von 120 Ohm (lt. Datenblatt) getauscht werden. Der Vorwiderstand Ra2 sollte für die blaue Diode entsprechend der gewählten Ausgangsspannung angepasst werden. Mir hat hier ein Wert von 33K ausgereicht, da es sich bei der LED wohl um eine Low Power Variante (If ~ 1-5mA) handelt. An der Qualität des Leiterplatte gibt es nichts zu bemängeln.

    Комментарии
    Показать оригинал
  • 04/07/2018

    The components and PCB are standard quality. Some component values differ from those in the schematics. The big capacitors were 2200 uF and 330 uF, which are good improvement. The LED series resistor was 4.7 k which cause some problems. In my package there was only one 120 ohm resistor where there should have been 2 and two 4.7 k resists when only one is used. The voltage adjustment components are poorly selected. The 120 ohm resistor provide roughly 10 mA to the 10 k multiturn trimmer resistor meaning the adjustment range is between 1.2 V to roughly 100 V! The LM317/337 an handle only max 37 V. I modified my circuits by using 360 ohm resistors instead. Note that LM317/337 are guaranteed to operate with minimum output current of 10 mA. The 360 ohm resistor does not guarantee that. A bigger and perhaps dangerous problem is the LED series resistor which is too small. The schematics says this should be 10 k, which also may be too low unless you use a power resistor. The maximum voltage over the resistor is roughly 70 V which means close 0.5 W power when 10 k resistor is used. And over 1 W when 4.7 k resistor is used. When I first time powered up my regulator there was a clear burning smell. Fortunately I used only 12 V transformer so the output levels were a bit over 16 V or 32 V total over the resistor+LED. I fast reduced the output to +/- 9V which was OK. When I tested +/-15V the temperature of the resistor rapidly rose to over 130 celsius!

    Комментарии (1)
    Показать оригинал
  • 13/06/2020

    excelent

    Комментарии
    Показать оригинал
  • 28/04/2020

    небольшой необходимый комплект, чтобы иметь в наличии

    Комментарии
    Показать оригинал
  • 22/02/2020

    Все хорошо и хорошо

    Комментарии
    Показать оригинал
  • 24/07/2019

    Correct

    Комментарии
    Показать оригинал
Show:

    Общий 0 страницы

    Перейти на страницу

    recommendation for you
    • US$8.19
    • US$9.99
    • US$18.99
    • US$3.99
    • US$5.99
    • US$8.49
    • US$9.39
    • US$7.49
    • US$12.99
    • US$5.99
    • US$11.99
    • US$104.99
    • US$32.99
    • US$8.99
    • US$7.99
    • US$8.99
    • US$28.99
    • US$5.99