Большая проблема только в том, что встроенный блок питания не очень мощный и вызывает узкое место. Отлично подходит для зарядки 1 или 2 аккумуляторов за раз, но для работы с параллельной платой требуется новый блок питания, так как максимальный ток составляет 3,4 А. Хороший четкий дисплей и простой интерфейс.

Great charger only issue is the built in power supply isn't very powerful and causes a bottleneck. Great for charging 1 or 2 batteries at a time, but need to get a new PSU to use my parallel board as it maxed out at 3.4 amps. Good clear display and simple interface.

Большая проблема только в том, что встроенный блок питания не очень мощный и вызывает узкое место. Отлично подходит для зарядки 1 или 2 аккумуляторов за раз, но для работы с параллельной платой требуется новый блок питания, так как максимальный ток составляет 3,4 А. Хороший четкий дисплей и простой интерфейс.

Be aware of the tiny display compared all other ISDT devices. See attached photo for comparison with BG-8S, Q8, SC-608, Q6 Pro and C4. In regards to the size of the 608AC a bigger display would be a good improvement. The firmware update to V1.0.0.24 introduced a self test error for discharge. After downgrading to V1.0.0.17 the self test reports no errors. There are no rubber pads as on the Q8, Q6 Pro or C4. This would have been good for desktop use. So this charger will more likely stay in the backpack for use only on the go.

Be aware of the tiny display compared all other ISDT devices. See attached photo for comparison with BG-8S, Q8, SC-608, Q6 Pro and C4. In regards to the size of the 608AC a bigger display would be a good improvement. The firmware update to V1.0.0.24 introduced a self test error for discharge. After downgrading to V1.0.0.17 the self test reports no errors. There are no rubber pads as on the Q8, Q6 Pro or C4. This would have been good for desktop use. So this charger will more likely stay in the backpack for use only on the go.

Be aware of the tiny display compared all other ISDT devices. See attached photo for comparison with BG-8S, Q8, SC-608, Q6 Pro and C4. In regards to the size of the 608AC a bigger display would be a good improvement. The firmware update to V1.0.0.24 introduced a self test error for discharge. After downgrading to V1.0.0.17 the self test reports no errors. There are no rubber pads as on the Q8, Q6 Pro or C4. This would have been good for desktop use. So this charger will more likely stay in the backpack for use only on the go.