Доставить в United Kingdom , USD
Самый положительный отзыв о %s на Banggood, Покупайте лучший %s по самой низкой цене на Banggood. Просмотрите самый полезный положительный отзыв о %s перед покупкой., радиоуправляемые игрушки, забавные виды спорта, фэшн, популярная электроника
Polizyste 29/05/2019
Does work like a charm on 2S with Ldarc 1103 Motors on DShot600 with 8kHz/8kHz Looptimes and Kingkong 65mm Props. BEC delivers enough Power for Runcam micro swift and 200mW VTX. After 8 batteries nothing to complain about. Super smooth, I absolutely love the feeling. Compared to an 20x20 stack you have a big weight saving on this. Sbus was on UART2 on the RC-pin. OSD is also working. Stack needs a good ventilation. On bench test it gets quite hot so give it enough air. For the price it does a perfect job!
7
Комментарии (9)
Оплатить
  • MightyMon HiPolizyste. trying to get SBUS working. What do you mean by UART2 on RC-pin. Isn't UART2 in Betaflight the RX2 pin? And isn't RC-pin UART1?

    Ответить 09/06/2019
  • Polizyste I didn't change anything from the stock settings. Just soldered to RC-pin and changed to Sbus iin configuration. Serialrx was activated on UART2 in betaflight. Rx2 didn't work for me.

    Ответить 15/06/2019
  • georgelagardo DearPolizyste, please tell me if the arrow printed on the flight controller is actually points to front, because my flight controller is showing wrong orientation when i point the arrow towards front . and i need to add 270 deg in yaw to correct it.

    Ответить 03/07/2019
  • Polizyste I didn't really care about the orientation. I oriented for ideal wiring (short wires) and changed the orientation like you. After remapping the Motor signals in CL in Betaflight everything was fine. I think the orientation wasn't preprogrammed right from factory!d

    Ответить 14/07/2019
  • BG484844112 what firmware do u use?

    Ответить 31/07/2019
  • Polizyste I'm still doing very fine on latest stable release of BF v3. Didn't try v4 yet. Target should be hakrc f411 like said in the description.

    Ответить 03/08/2019
  • ChristianHilario Hey Polizyste, what frame are you using? I installed this in a FullSpeed Toothpick frame with 1103 7800kv and HQprop 65mm. It flies fine for about 30 seconds then falls to the ground. Motor keeps running "fine" but won't lift off.

    Ответить 20/09/2019
  • Polizyste I also noticed this problem using 2S on 1304 Motor loaded with 3" props at 96g AUW. If possible you should Upgrade to 2S lipo (lower amp Draw). I only noticed this issue while hovering, no Problems when flying acro, so I think it's an overheating protection.

    Ответить 05/12/2019
  • Polizyste I also noticed that the amp with all the new functions of BF v4 activated is much Higher than Stock setting in BF v3!

    Ответить 05/12/2019
Онлайн-консультант
Опрос удовлетворенности

Скачать приложение, чтобы получить эксклюзивный 10% off купон