Отзывы покупателей

Написать отзыв
  • Все отзывы (6913)
  • Образ (756)
  • Видео (12)
  • Все звезды
    • Все звезды(6913)
    • 5 Звезда(6629)
    • 4 Звезда(238)
    • 3 Звезда(33)
    • 2 Звезда(5)
    • 1 Звезда(8)
Сортировать по:
оценке
  • оценке
  • полезности
  • дате
Отзывы только из вашей страны (Russian Federation)
|
Показать оригинал

Часть обзора переведена автоматически.

  • 24/09/2015

    Bez przeróbek mierzy dwuprzewodowo (zasilanie pobierane z mierzonego napięcia) od 3,5V do 29,9V. Powyżej 29,9V pokazują się poziome kreski i świecą wszystkie kropki. Aby przerobić na zakres od zera trzeba wylutować diodę oznaczoną S4 (czarny sześcianik) i w miejscu kontaktu plusa diody przylutować oddzielny cienki przewód do zasilania stabilizatora napięcia (oznaczenie 7133H) osobnym napięciem dodatnim względem masy (czarny przewód) w granicach od +3,5V do +30V. Mierzone napięcie dodatnie podłączyć jak poprzednio między przewody czarny i czerwony. Niestety woltomierz nie mierzy napięć ujemnych względem masy (czarny przewód). Niewielkie wymiary pozwalają wbudować go w zasilacz, prostownik itp. Żurek Janusz

    Комментарии
    Показать оригинал
  • 18/11/2017

    This meter is quite nice. I had to calibrate almost all of these meters I bought. Once calibrated they were fairly accurate. The LEDs were not seated on any of the circuit boards. I was able to desolder the LEDs and resolder them so that they were properly seated. Very good value overall. I noticed that there was a location for a third wire. I traced the circuit and realized that if the zero jumper was removed and a third wire was added, it was possible to measure voltages down to zero. Please look at the photo to see the jumper location. The red and black wires must be connected to a power source, the white wire is connected to what voltage you want to measure. You must connect the ground of the power source to the ground reference of the voltage you want to measure.

    Комментарии (6)
    Показать оригинал
  • 19/03/2017

    I bought these partly because they are meant to be easy to convert to 3 wire operation - using a separate battery to power the meter to the voltage source being measured. The instructions are to remove the link below the adjustment trimpot and solder a wire onto the 3rd connection point. What I didn't realise was how tiny the link was. I didn't realise just how tiny the link was going to be but I managed to remove it after a few attempts - surprisingly without doing any apparent damage. Then I soldered a wire to the 3rd point (the yellow wire in the photos). Connect the Red and Black wires to the +ve and -ve of a battery to power the meter (3-30v) and connect the 3rd wire (Yellow) to the +ve point to measure and link the -ve point back to the Black wire.

    Комментарии (2)
    Показать оригинал
  • 14/02/2021

    Я приобрел желтую версию мини цифрового вольт измерителя, что важно, потому что это возможно, что например. синяя версия может не работать так хорошо при более низком напряжении, чем желтый. (У меня пока нет синей версии) (Синие светодиоды имеют 3 В, а желтый должен иметь >=2 В) Я также только проверить только один из многих образцов я купил, так что этот тест не может объяснить точность по всем 32pcs я купил. Я могу только сказать, что этот единственный пример будет работать между 2,5 В и проверенные 5 В абсолютно точным до второго числа. При напряжении 2,5 В он также будет работать, но светодиод погаснет, и точность будет дрейфовать на 0,1 В. На задней стороне, кажется, есть потенциометр, так что может быть возможно настроить счетчик, если он не точный. Я пока не тестирую это, потому что я не хочу менять его на рабочем устройстве. Я также не тестирую его до 30 В, потому что я хочу использовать столько счетчиков напряжения, чтобы перезагрузить батарею 16s. Я не могу сказать, сколько тока он будет потреблять, потому что я сейчас сожгла все предохранители своих счетчиков. Более 1 Ом shuntresistor на 3,6 В источник напряжения 0,009 В падает, так что ток на 3,6 В должен быть 9 миллиампер, если я неправильно его. В любом случае, не рекомендуется все время пускать светодиод на клетки, чтобы предотвратить глубокий разряд.

    Комментарии (2)
    Показать оригинал
  • 07/09/2017

    I've bought this digital voltmeter to modidy my LiitoLala Lii-100 battery charger. Now I can use the charger as a simple voltage tester too.

    Комментарии
    Показать оригинал
  • 28/02/2016

    I bought two of these RED LED units for a trial and was quite surprised by the accuracy. The little trimmer on the rear of the PCB can be adjusted to calibrate the reading. I calibrated it at 12V and found it matched all input voltages from 4V up to 29.9V. Also as a bonus you can use an independent input for the reading. Simply remove the 0R resistor from the PCB (beside the trimmer) and hook an extra wire up to the spare hole beside the (+) input. Power the unit up (5V - 30V) and it will read from 0 to 29.9v using the independent input. Using this method it should be possible to get any colour LED unit to do the same.

    Комментарии
    Показать оригинал
  • 17/11/2017

    Very small and good quality voltmeter. I go with the blue version and i like it. Its very accurate like you can see on my pictures. Dont forget to order these https://bit.ly/MuLeads test lead wires so you can solder it to the mini tester. I will install it to my workbench so i have a mini voltmeter that i can use very fast. Also check out this nice alternative tester >>> https://bit.ly/MinVolt

    Комментарии
    Показать оригинал
  • 30/09/2017

    This is my iforce2d cheep ass transmitter. I never knew how much power was left in the batteries until now. I purchased four of these 2 in Yellow 2 in blue. I highly recommend them. they are available in bulk also.

    Комментарии
    Показать оригинал
  • 31/05/2015

    These are great little digital voltmeters for my drone & quad copter projects. I bought all 4 colors so I could customize my projects with their various colors. Going to order extra to have for future projects because they are priced right.

    Комментарии
    Показать оригинал
  • 07/07/2019

    Ein sehr gutes Display das genau misst. Bei Bedarf kann auf der Rückseite justiert werden.

    Комментарии
    Показать оригинал
Show:

    Общий 0 страницы

    Перейти на страницу

    Рекомендуем

    recommendation for you
    • US$43.99
    • US$17.99
    • US$29.99
    • US$12.99
    • US$12.54
    • US$8.99
    • US$11.99
    • US$15.14
    • US$7.99
    • US$229.00
    • US$13.84
    • US$25.99
    • US$30.49
    • US$13.99
    • US$18.99
    • US$21.49
    • US$323.00
    • US$6.49