BG133639481 Exact same issue here… not good at all. Did you ever get a resolution?

Оплатить

rupert Hi,I had the same problem and after some thought placed thin shims (1mm) between the red T piece and the sliding bar and then tightened the cross head screws ensuring the slider was square to the beam, though if its slightly out I doubt it would have an appreciable effect. It all works now as it should do. Given that I won't ever be dismantling the head piece now that its set this seemed the best option preferable to removing some metal. Hope this helps.

Оплатить

rupert HiI had the same problem and after some thought inserted thin shims (about 1mm) between the slider and the T head, checked for the slider for square with the beam and then tightened the cross head screws. As I won't have any need to dismantle these pieces again it seems a good fix -all is working fine now. Hope this helps.

Оплатить

BG212174311 Sameissue here.. the support offers only some minor discount - not satisfactory. I'm think of using my router with HSS spiral bit to mill of the 1 mil of material, but not yet sure how get it squared enough.

Оплатить