Доставить в United Kingdom , USD
Самый положительный отзыв о %s на Banggood, Покупайте лучший %s по самой низкой цене на Banggood. Просмотрите самый полезный положительный отзыв о %s перед покупкой., радиоуправляемые игрушки, забавные виды спорта, фэшн, популярная электроника
jumika 20/10/2022
Make sure you check / reassemble the preassembled gantrys. For me it was way off and the z axis could barely move. Other that that so far it is working nicely. I did not try high temp filaments for now. The stock software is lame i think to be honest i can't relly remember what was my issue with it, but i remember that there was multiple issues so i was not satisfied with it. I've already installed klipper so i can't check it now. If you can, install klipper. The first mod you should do is the ribbon cable guide seen on my images. Without that the ribbon cable flexes very much at the end of the X axis range. Be aware that this is somewhat limiting the max height of your prints because it guides the cable upward. For the full price i think it is kinda overpriced. i've payed around 430 eur for it which is an ok buy i think. If the s1 would have the same amount of discount i would went wit that and a bimetal heatbreak.
0
Комментарии
Оплатить
Онлайн-консультант
Опрос удовлетворенности

Скачать приложение, чтобы получить эксклюзивный 10% off купон