The title is a little misleading. It is an IR LED for transmitting IR signals only. It works for sending remote control signals from an ESP8266. There are no other components on the board just the IR LED and the connector. The middle pin is not connected. Use the outer two (S and -).

The title is a little misleading. It is an IR LED for transmitting IR signals only. It works for sending remote control signals from an ESP8266. There are no other components on the board just the IR LED and the connector. The middle pin is not connected. Use the outer two (S and -).

The title is a little misleading. It is an IR LED for transmitting IR signals only. It works for sending remote control signals from an ESP8266. There are no other components on the board just the IR LED and the connector. The middle pin is not connected. Use the outer two (S and -).

It arrived twisted, as you can see, but not damaged, I just straightened it and voila! I tested it and works perfectly. For those starting in electronics, the device does not emit on 38kHz automatically, you need set the Arduino to send the signal in the right pin.

It arrived twisted, as you can see, but not damaged, I just straightened it and voila! I tested it and works perfectly. For those starting in electronics, the device does not emit on 38kHz automatically, you need set the Arduino to send the signal in the right pin.

It arrived twisted, as you can see, but not damaged, I just straightened it and voila! I tested it and works perfectly. For those starting in electronics, the device does not emit on 38kHz automatically, you need set the Arduino to send the signal in the right pin.