I used this to connect a minimOSD to my CX-20 (with APM 2.5.2), with two small modifications: 1) On the connector use a hobby knife to shave the two protrusions that prevent the connector from fitting into the FC's UART port. (These would be along the edge that will be closest to the circuit board.) 2) Reverse the order of the wires so that the colors are correct for this APM. Ground is on the side closest to the USB port. The one next to GND can be removed. +5V is at the end opposite GND.

I used this to connect a minimOSD to my CX-20 (with APM 2.5.2), with two small modifications: 1) On the connector use a hobby knife to shave the two protrusions that prevent the connector from fitting into the FC's UART port. (These would be along the edge that will be closest to the circuit board.) 2) Reverse the order of the wires so that the colors are correct for this APM. Ground is on the side closest to the USB port. The one next to GND can be removed. +5V is at the end opposite GND.

I used this to connect a minimOSD to my CX-20 (with APM 2.5.2), with two small modifications: 1) On the connector use a hobby knife to shave the two protrusions that prevent the connector from fitting into the FC's UART port. (These would be along the edge that will be closest to the circuit board.) 2) Reverse the order of the wires so that the colors are correct for this APM. Ground is on the side closest to the USB port. The one next to GND can be removed. +5V is at the end opposite GND.

la calidad es aceptable.

la calidad es aceptable.

la calidad es aceptable.