Язык
Доставить в 
United Kingdom , USD
United Kingdom , USD
United Kingdom , USD
38% OFF
Сборный экструдер горячего конца 2 в 1 с насадкой 0,4 мм для 3D-принтера с диаметром прутка 1,75 мм
16,60€
26,75€
View It
Lawrence I finally installed this with a second Tevo Titan extruder on my Tevo Tornado. First thing, it fitted with no modification, the hotend cover goes straight over and the heating element and thermistor are a straight swap. So far so good. It sits a little lower than standard so a bit of bed levelling needed - no problem. Then I tried printing and it clogged. Not the nozzle but the tube through the heatbreak. I cleaned it out and re-fitted it. Lowered temperature of nozzle and it clogged again.
Ответить 22/01/2019
Lawrence Fixed it by disassembling and lining the tube with PTFE tube (suitable opened at one end) Now it seems to work fine (I hope)
Ответить 22/01/2019
Lawrence Itclogs in the tube through the heat break. I took it apart and it put in some PTFE tube. It doesn't clog but it doesn't work consistently.
Ответить 29/01/2019| О компании | Cвязаться с нами | Оплата и доставка | Партнерские программы |
|---|---|---|---|
